TODP Black Edition S6 #56 “Red Forest”

This is a special edition “Red Forest” design, prepared, painted, hand-drawn, and finished by the Somerset based artist Mutartis. Each artwork is unique.

These pedals are currently fitted with Series 6 “Black Edition” boards, with extended gain and filter cut ranges, compared with previous builds. This board on this model has adjustable upper gain bump-stop and and an extended filter cut range, compared with previous builds. These also have the -V mil-spec tubes fitted, and also have an adjuster to keep the bias level at its peak. There are also other colourful surface mounted components, which change the function of the filter sweep, and trim the tube filament voltage.

The fully-assembled “Black Edition” units are only available in Australia, Canada, Japan and the USA. If you are in business the UK, the EU or Europe, please get in touch using the contact form here: /contact-us/

The TODP (Tube Overdrive Distortion Plus) is a veritable toolkit of overdrive and distortion, which can give you a huge range of breakup from a soft tube clip, to full-on metal or punk distortion, with all kinds or blues and rock options in the middle. *

There are pre-cut and post-boost options for the low end, which can be used together to give a more mid oriented break up in the tube. The high end can be tamed with passive Filter control pot.

All 6 settings utilise the tube device, with increasingly more noticeable tube effect, as you go from germanium to ABN:

  • 3x “hard clipping” diode distortion settings: 70s / germanium, 80s / silicon and 90s / LED
  • 3x tube (valve) overdrive settings: AB2 – where you can hear the 2x silicon diodes affect the break up, AB4 – where the 4x silicon diodes are largely inaudible, or ABN – where the compression is controlled in a classic 50s / 60s way

The Soviet era thermionic valve / tube and germanium diodes in the TODP have not been RoHS tested and certified, and hence it does not meet EU RoHS 1. This does not fall under the scope within the relevant act in New York State, and is not a covered item (mainly computer monitors) in California, and hence should be allowed. If you are unsure about whether this allowed in your country or state, please contact us before ordering, as we will not be held responsible for compliance once the pedal has been dispatched.

* amount of distortion and overdrive will depend on many factors, including gain range of pedal, guitar setup, and pick-up types. The gain assignment for this release is Mid-Range (500K). The range of these offers a balance between a more “transparent” overdrive at lower gains, and giving better control of the gain. Four of the modes create distortion mainly by overdriving a thermionic rod type valve (or tube).

** colours and print quality will vary; the theme is painted and printed to give this variation.

Please read our Terms and Conditions of Sale.

Additional information

Artwork

Custom hand-painted and drawn "Red Forest" by Mutartis

Input pre EQ

First order bass cut (220Hz default)

Clipping options

Germanium, silicon and LED clipping diodes to 2, 4 or no anti-blocking diodes on the tube

Pentode load

47KΩ hi clip, 200KΩ low clip, or 100KΩ middle

Recovery boost EQ

First order bass boost (default 220Hz and 80Hz)

Recovery boost 6db / 0dB / 12dB

Used to recover volume after, especially germanium and silicon, clipping crushes the signal, or can be used to slam the signal, to add op amp clipping to the mix

Board colour / series

Black Edition S6, non-UK/EU assembled loaded with 1J29B-V tube

Tone profile

These are all fitted with standard-range (500K) gain pots.

These are fitted with Red LEDs.

£259.00

Out of stock